FAQ Frequently Asked Questions


What is Tinst? Why Tinst specified values are necessary to maintain? What will happen of Tinst values are applied more or less?

Tinst means “Installation Torque” which is applied on the bolts during the nut tightening process. Maximum allowable values for the Tinst corresponding to the each profile type, bolt diameter and grade of T-bolt are given in the European Technical Assessment (ETA-09/0338) annex B7. If T-bolts are highly overtorqued the bolt material can be overstressed and can also damage the channel lips and will cause reduction in the load carrying capacity. On the other hand, if Tinst applied is less than the specified value which can cause the movement in the fixture. Therefore, JORDAHL recommends to use the given installation torque values as a guideline for installation.

Can I position the loads along the longitudinal direction of the anchor channels without using the toothed anchor channels?

Yes, with JORDAHL® hot rolled anchor channels it is possible to take small to medium loads along the length of the anchor channels. Then instead of using the Hook-Head or Hammer- Head bolts, special double notched toothed bolt types JKB and JKC should be used. The installation torques of these bolts are higher creating a groove inside the channel lips thereby enhancing its load carrying capacity along the longitudinal direction of the anchor channel.

Are there different types of stainless steel for anchor channels?

For the selection of suitable anchor channels, the various corrosive conditions must be observed at the site. An overview of the applications and appropriate materials is shown in the European Technical Assessment ETA-09/0338. For stainless steels there is a difference between applications with high corrosion, such as corrosion in areas exposed to weather and near the seaside and with very high corrosion applications e.g. because of chlorides and sulphur dioxides such as lroad tunnels.

Is the ETA 09/0338 also valid for stainless steel?

In the European Technical Assessment ETA 09/0338 the available materials are listed in Annexes 2 and 3. ETA is also available for stainless steel in various grades for both channels and bolts. The resistances of the channels made of stainless steel correspond to those of hot-dip galvanized channels. Annexes C2 and C5 show the resistances of stainless steel bolts.

Is there design software for anchor channels?

Since the beginning of 2011 the JORDAHL GmbH offers a user-friendly software for free download. This facilitates users to switch from the previous rigid design according to tables on a flexible design according to ETA.

Technical Consulting - our JORDAHL Experts

You are always well advised when you choose JORDAHL products. You can contact us directly from Monday to Thursday from 8:00 a.m. to 5:30 p.m. We’re looking forward to hearing from you.